Engineering drawing - I / M.B. Shah, Rana B.C

Contents

chapter 1 Basics of engineering drawing
1.1 drawing instruments
1.2 lettering
1.3 conventional lines, etc

chapter 2 Geometry constructions, Loci and plane curve
2.1 geometrical constructions
2.2 loci of points and plane curves
2.3 Loci with are straight lines or circular arcs, etc

chapter 3 Projections of points
3.1 introduction
3.2 orthographic projections

chapter 4 Projections of lines
4.1 introduction
4.2 angle between a straight line and a plane of projection
4.3 projection of lines parallel to both, the HP and the VP, etc

chapter 5 Projections of planes
5.1 introduction
5.2 angles between a plane surface and a principle plane
5.3 projections of planes parallel to VP, etc

chapter 6 Projections on Auxiliary planes
6.1 introduction
6.2 projections of a point on an auxiliary vertical plane
6.3 projections of a point on an auxiliary inclined plane

chapter 7 Projections on Solids
7.1 introduction
7.2 solids
7.3 orthographic projection of solids, etc

chapter 8 Sections of solids
8.1 introduction
8.2 section planes
8.3 projections of sections and sectional views

chapter 9 Multi-view Orthographic projections
9.1 projection
9.2 orthographic projection
9.3 multi-view orthographic projection, etc

chapter 10 Sectional View
10.1 introduction
10.2 projection of sectional views
10.3 full section, etc