Fundamentals of machine design : vol. 4 /
Orlov, P.
Fundamentals of machine design : vol. 4 / Orlov P. - Moscow : MIR publishers, c1980. - 386 p. : ill. ; 23 cm.
Table of contents;
Chapter 1 Torque transmission
1.1 Keyed joints
1.2 Splined and serrated joints
1.3 Prismatic and shaped shaft-end joints
1.4 Pinned joints
1.5 Flanged joints
Etc.
Chapter 2 Plain (sliding-contact) bearing
2.1 Clearances
2.2 Fluid, semifluid and semidry friction
2.3 Hydrodynamic lubrication
2.4 Calculation of fluid-friction bearings
2.5 Introduction of oil into bearings
Etc.
Chapter 3 Antifriction (Rolling-contact) bearings
3.1 Types of bearings
3.2 Materials
3.3 Manufacturing accuracy grades
3.4 Coefficient of friction. Allowable peripheral speeds
3.5 Load-carrying capacity and durability
Etc.
Chapter 4 Lock (Snap) rings
4.1 Lathe-turned rings
4.2 Wire rings
4.3 Punched rings
4.4 Axial locking in stop joints
4.5 Reinforcing stop joints
Etc.
Includes Index : p. 383-386
Machine design
621.815 / ORL
Fundamentals of machine design : vol. 4 / Orlov P. - Moscow : MIR publishers, c1980. - 386 p. : ill. ; 23 cm.
Table of contents;
Chapter 1 Torque transmission
1.1 Keyed joints
1.2 Splined and serrated joints
1.3 Prismatic and shaped shaft-end joints
1.4 Pinned joints
1.5 Flanged joints
Etc.
Chapter 2 Plain (sliding-contact) bearing
2.1 Clearances
2.2 Fluid, semifluid and semidry friction
2.3 Hydrodynamic lubrication
2.4 Calculation of fluid-friction bearings
2.5 Introduction of oil into bearings
Etc.
Chapter 3 Antifriction (Rolling-contact) bearings
3.1 Types of bearings
3.2 Materials
3.3 Manufacturing accuracy grades
3.4 Coefficient of friction. Allowable peripheral speeds
3.5 Load-carrying capacity and durability
Etc.
Chapter 4 Lock (Snap) rings
4.1 Lathe-turned rings
4.2 Wire rings
4.3 Punched rings
4.4 Axial locking in stop joints
4.5 Reinforcing stop joints
Etc.
Includes Index : p. 383-386
Machine design
621.815 / ORL