000			02033nam a22002177a 4500
003			OSt
005			20230804070638.0
008			210212b ||||| |||| 00| 0 eng d
040			_aBUL _bENG _cBUL _dBUL _eRDA
082			_222 _a604.25 _bSHA
100			_aShah, M.B
245			_aEngineering drawing - I / _cM.B. Shah, Rana B.C
250			_a1st edition.
260			_aPune : _bTechnova publications, _cc1997.
300			_avarying pages : _bill. ; _c24 m.
500			_aContents chapter 1 Basics of engineering drawing 1.1 drawing instruments 1.2 lettering 1.3 conventional lines, etc chapter 2 Geometry constructions, Loci and plane curve 2.1 geometrical constructions 2.2 loci of points and plane curves 2.3 Loci with are straight lines or circular arcs, etc chapter 3 Projections of points 3.1 introduction 3.2 orthographic projections chapter 4 Projections of lines 4.1 introduction 4.2 angle between a straight line and a plane of projection 4.3 projection of lines parallel to both, the HP and the VP, etc chapter 5 Projections of planes 5.1 introduction 5.2 angles between a plane surface and a principle plane 5.3 projections of planes parallel to VP, etc chapter 6 Projections on Auxiliary planes 6.1 introduction 6.2 projections of a point on an auxiliary vertical plane 6.3 projections of a point on an auxiliary inclined plane chapter 7 Projections on Solids 7.1 introduction 7.2 solids 7.3 orthographic projection of solids, etc chapter 8 Sections of solids 8.1 introduction 8.2 section planes 8.3 projections of sections and sectional views chapter 9 Multi-view Orthographic projections 9.1 projection 9.2 orthographic projection 9.3 multi-view orthographic projection, etc chapter 10 Sectional View 10.1 introduction 10.2 projection of sectional views 10.3 full section, etc
650			_aEngineering drawing.
650			_aEngineering.
700			_aRana, B.C
942			_2ddc _cBOOK-CA _e1st edition. _h604.25 _i1 _kSHA _m604.25 SHA
999			_c1081 _d1081